Tech Video Clips

Schematic: Push Button Connected to Microcontro...

Schematic of a push button connected to a microcontroller. One lead of the push button is connected to a general I/O pin of the microcontroller and the other lead is...

Schematic: Push Button Connected to Microcontro...

Schematic of a push button connected to a microcontroller. One lead of the push button is connected to a general I/O pin of the microcontroller and the other lead is...

Saving Files in Programmers Notepad (WINAVR)

How to save files in programmers notepad under WINAVR.

Saving Files in Programmers Notepad (WINAVR)

How to save files in programmers notepad under WINAVR.

Right Angle Headers

Right angle or L shaped headers to allow a board to connect in a right angle to another board or female header IDC connector.

Right Angle Headers

Right angle or L shaped headers to allow a board to connect in a right angle to another board or female header IDC connector.

Results: Single LED Turn On with the AVR

The results of the single LED circuit and program of turning on the LED using PORTB and Pin 0 after the program was transfered into the AVR microcontroller.

Results: Single LED Turn On with the AVR

The results of the single LED circuit and program of turning on the LED using PORTB and Pin 0 after the program was transfered into the AVR microcontroller.

Result: Using UART/USART One Way Communication

This is the result of the one way communication of one microcontroller transmitting through its TX pin and another microcontroller receiving through the RX pin. A push button switch is...

Result: Using UART/USART One Way Communication

This is the result of the one way communication of one microcontroller transmitting through its TX pin and another microcontroller receiving through the RX pin. A push button switch is...

Result: Using Interrupts with the Timer/Counter

The interrupt can be used to create an event when the timer/counter TCNT1 or TCNT0 achieves a specific value. The OCR1A is used to hold this value. The TCCR1B is...

Result: Using Interrupts with the Timer/Counter

The interrupt can be used to create an event when the timer/counter TCNT1 or TCNT0 achieves a specific value. The OCR1A is used to hold this value. The TCCR1B is...