Tech Video Clips

Result: Adjusting the PWM Pulse Width to a Valu...

The OCR1A is adjusted to 900 to create a .9 ms Pulse width. The horn did not turn to the expected extreme, so the number will need to be adjusted...

Result: Adjusting the PWM Pulse Width to a Valu...

The OCR1A is adjusted to 900 to create a .9 ms Pulse width. The horn did not turn to the expected extreme, so the number will need to be adjusted...

Result: Adding the 'x=' and 'y=' for the 'x' Cy...

Modifying the program so that the xa nd y location values are shown on the LCD screen while the 'x' chasing character runs through all of the LCD cursor locations.Structure:...

Result: Adding the 'x=' and 'y=' for the 'x' Cy...

Modifying the program so that the xa nd y location values are shown on the LCD screen while the 'x' chasing character runs through all of the LCD cursor locations.Structure:...

Result: ADC (Analog to Digital Conversion) usin...

A potentiometer is connected to the ADC using voltage divider connection to vary the voltage to the ADC pin. The output of the voltage to digital number is displayed on...

Result: ADC (Analog to Digital Conversion) usin...

A potentiometer is connected to the ADC using voltage divider connection to vary the voltage to the ADC pin. The output of the voltage to digital number is displayed on...

Result: ADC (Analog to Digital Conversion) Rang...

The result from the ADC using the internal 2.56v reference and the accelerometer set at 1.5g is 325 at completely vertical and rotated 180 degrees the result is 963. This...

Result: ADC (Analog to Digital Conversion) Rang...

The result from the ADC using the internal 2.56v reference and the accelerometer set at 1.5g is 325 at completely vertical and rotated 180 degrees the result is 963. This...

Result: ADC (Analog to Digital Conversion) Gett...

The ADLAR is not set in this program because it is 0 (right adjusted) by default. When a 10-bit number is desired from the ADC conversion, both the ADCH and...

Result: ADC (Analog to Digital Conversion) Gett...

The ADLAR is not set in this program because it is 0 (right adjusted) by default. When a 10-bit number is desired from the ADC conversion, both the ADCH and...

Result: ADC (Analog to Digital Conversion) Gett...

Result of hte ADC 10-bit conversion shown on the LDC. When a 10-bit number is desired from the ADC conversion, both the ADCH and ADCL must be used to get...

Result: ADC (Analog to Digital Conversion) Gett...

Result of hte ADC 10-bit conversion shown on the LDC. When a 10-bit number is desired from the ADC conversion, both the ADCH and ADCL must be used to get...